Pilight Binary Sensor
The pilight
binary sensor platform implement the pilight hub binary sensor functionality. Two type of Pilight binary sensor configuration available. A normal sensor which send the on and off state cyclical and a trigger sensor which send only a trigger when an event happened (for example lots of cheap PIR motion detector).
To enable a Pilight binary sensor in your installation, add the following to your configuration.yaml
file:
# Example configuration.yml entry
binary_sensor:
- platform: pilight
variable: 'state'
Configuration variables:
- variable (Required): The variable name in the data stream that defines the sensor value.
- payload (Required): Message payload identifiers. Only if all identifiers are matched the sensor value is set.
- name (Optional): Name of the sensor.
- payload_on (Optional): Variable
on
value. The component will recognize this as logical ‘1’. - payload_off (Optional): Variable
off
value. The component will recognize this as logical ‘0’. - disarm_after_trigger: (Optional): Configure sensor as trigger type.
- reset_delay_sec (Optional): Seconds before the sensor is disarmed if
disarm_after_trigger
is set to true. Default is 30 seconds.
A full configuration example could look like this:
# Example configuration.yml entry
binary_sensor:
- platform: pilight
name: 'Motion'
variable: 'state'
payload:
unitcode: 371399
payload_on: 'closed'
disarm_after_trigger: True
reset_delay_sec: 30